Vibration pedestal
Product introduction

Damping pedestal is also known as damping pedestal, inertia pedestal, inert block, water pump pedestal, etc. There are many points on the water pump. With the higher and higher requirements for engineering quality and equipment quality, the vibration damping pedestal has gradually become a product of concern to businesses.




The purpose of selecting the damping pedestal is to increase the size and weight of the equipment base, reasonably arrange the center of gravity of the equipment, increase the stability of the equipment, and reduce the transmission of the equipment vibration.




When designing the water pump pedestal, the regulations clearly stipulate:




1. The length of the damping pedestal shall not be less than the length of the common pedestal of the water pump unit;




2. The width of the water pump pedestal shall not be less than that of the common base of the water pump unit, and the distance from the anchor bolt center of the common base to the inert fast side line shall not be less than 150 mm.




3. The height of the damping pedestal shall be 1 / 10-1 / 8 of the length, and shall not be less than 150 mm;




4. the mass of the damping pedestal shall not be less than the total mass of the water pump unit, generally 1.0-1.5 times of the total mass of the water pump unit.




5. The size of the vibration damping pedestal shall be calculated as the integral multiple of 10 mm.




6. The pedestal shall be equipped with reinforcement, and the concrete grade shall not be less than C18.




In the daily design and manufacture of water pump pedestal, as long as the above standards are referred to, the product is definitely qualified.


Technical parameter
Sample display
Copyright ? 2018 版權所有:上海青浦震新減振器廠  滬ICP備09063763號 技術支持:
国产免费牲交视频